ADATA presents SR1010 SSD line for corporate customers

ADATA presents SR1010 SSD line for corporate customers

The Taiwanese maker of memory and storage solutions ADATA has presented its latest product – the SR1010 solid-state drive line, designed for use with corporate customers. The new drives offer a 2.5-inch form factor, 7 mm of thickness, support for SATA 3.0 and capacities of 100 GB, 240 GB and 480 GB.

The SR1010 line is based on the Seagate SF2581 controller and uses MLC NAND flash memory. The drives reach up to 550 MB/sec of read speed and 73 000 IOPS when reading and 45 000 IOPS when writing. The drives also make use of various technologies that include TRIM, NCQ, S.M.A.R.T., NVMe and AHCI. The built-in error correction capability is also worth noting as well as the low power consumption – the SR1010 needs 4.1W when operating and just 2.25W when in idle mode.

The SR1010 line comes with a 5-year warranty but it is unclear how much these drives cost.

Source: ADATA

Related posts

First specs of Radeon R9 380X emerge

First specs of Radeon R9 380X emerge

It is quite clear now that by the end of the year AMD plans to launch a new high-end graphics card that will compete with the GeForce GTX 980. There was even speculation the card would be called Radeon R9 380X but until now we haven’t had any specs in particular. Online sources now claim the...

Samsung Solar Powered netbook up for pre-order

Here is another interesting solution on the laptop market, a solar powered netbook from Samsung called NC215s1. The 10.1-inch netbook is equipped with built-in solar cells on its back lid, which will give you an extra work time when the battery runs out. Spec-wise this laptop comes with...

CyberPower releases Zeus Storm line of gaming PCs

CyberPower is again in the news today with the release of the all new Zeus Storm line of gaming desktop PCs – represented as of now by three models offering both Intel and AMD processors and both AMD and NVIDIA graphics cards. The cheapest of the three is the Zeus 1000 model – it...

Leave a comment